Topology services in the campus manager 3.2 doesnot show the link alone which are connected through 1000 Base T interface.End device is shown as green and also reachable from cisco works system. How it is connected it is not able to show...?
is there any workaround present.. or any patches to be installed..
Campus Manager uses CDP information to draw links, so check that the CDP neighbor information from both devices is consistent with the physical connections and device IP. You could look into this in depth with snmpwalks on the CDP-MIB to see if snmp is reporting the same as CLI on the device.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.