10-02-2002 01:25 AM - edited 03-02-2019 01:47 AM
Hello all,
Can I config cisco 3550 with IPX layer 3 switch? Because I just can find few commands about IPX in the software guide of 3550. Thank You!
Best Regards
Teru Lei
Solved! Go to Solution.
10-02-2002 05:03 AM
The CAT3550 is a IP only box. If you have any non IP protocols, use fall back bridging
http://cio.cisco.com/univercd/cc/td/doc/product/lan/c3550/12111ea1/3550scg/swfallbk.htm
Since 3550 runs IOS, you might see few IPX commands in the parser, but they are not valid for this box
10-02-2002 05:03 AM
The CAT3550 is a IP only box. If you have any non IP protocols, use fall back bridging
http://cio.cisco.com/univercd/cc/td/doc/product/lan/c3550/12111ea1/3550scg/swfallbk.htm
Since 3550 runs IOS, you might see few IPX commands in the parser, but they are not valid for this box
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide