Re: Can CRB or IRB be used just for specific protocol?
Yes, you can - though the function is best expressed as "Route IP, bridge everything else."
I believe the command to set this up has you specify which protocols will be routed, and everything else is bridged.
I suppose if you only wanted to route IP, and bridge only Appletalk, you have to configure the router to route every protocol on your wire (for the protocols you want blocked, route them to Null) then bridge Appletalk.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...