Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can CW2K support SSH instead Telnet or Both?

I have problem connecting to monitered device through Telnet. If i have SSH enabled on device, Does CW2K will able to connect to device through SSH?

Thanks in advance.

Jay

8 REPLIES
Blue

Re: Can CW2K support SSH instead Telnet or Both?

Yes, for Config Management, it depends on the order set under RME->Administration->Config Management->General Setup->Transport Setup and set the order.

Re: Can CW2K support SSH instead Telnet or Both?

But my understanding was that some CW components (Campus Manager, e.g.) were not SSH compliant? And could not be installed on the same server as RME using SSH then?

Regards,

Milan

Blue

Re: Can CW2K support SSH instead Telnet or Both?

What you're referring to above is the SSL/https compliance and not SSH. Yes, Campus Manager is not SSL/https compliant and cannot be install with RME is SSL is enabled. But the question here is related to SSH and not SSL/https.

New Member

Re: Can CW2K support SSH instead Telnet or Both?

To follow this on the SSH issue, the above mentioned steps cover RME, but is there a way to get Campus manager, Ciscoview etc to use SSH? Can the underlying files be modified to change the command pushed down to the client?

Thanks.

New Member

Re: Can CW2K support SSH instead Telnet or Both?

There are only three Transport protocol on list TELNET, TFTP and RCP.

I don't have choice for SSH.

Thanks

Blue

Re: Can CW2K support SSH instead Telnet or Both?

Support for SSH was added in RME 3.4 and later only. If you're running RME 3.3 and earlier versions, you will not see the SSH option in settings.

New Member

Re: Can CW2K support SSH instead Telnet or Both?

Thank you very much.

Jayesh

New Member

Re: Can CW2K support SSH instead Telnet or Both?

What about devices that do not support SSH yet?

If I set the order to SSH, TFTP, Telnet, RCP how will this affect devices that are not SSH capable.

I am assuming that if they do not support SSH then they will try the next options, in order and should still work.

There is a ssh client of some sort built into CW2K so no further set up is needed for CW2K to use SSH.

103
Views
0
Helpful
8
Replies