01-30-2004 11:04 PM - edited 03-02-2019 01:16 PM
Hi,
I have a 2612 router with BRI ports. i wanted to allow my remote users to dail-into BRI ports using PSTN(analog) line at their end. is this possible?
regards
Manoj
01-31-2004 09:12 AM
Hello,
to my best knowledge, analog users can only dial in when you have one of the following installed in your 2621, it won´t work with BRI ports:
Analog Dialup and Remote Access Network Modules
NM-8AM 8-Port Analog Modem Network Module
NM-16AM 16 Port Analog Modem Network Module
NM-8AM-V2 8 port Analog Modem Network Module with V.92
NM-16AM-V2 16 port Analog Modem Network Module with V.92
HTH,
Georg
02-03-2004 10:54 AM
Not sure, but try the command "isdn incoming-voice modem" on the bri. The below doc is for C3640.
http://www.cisco.com/en/US/tech/tk801/tk379/technologies_configuration_example09186a0080093c6e.shtml
02-04-2004 06:49 AM
You can use the Digital Modem module to terminate the call via the BRI port too. The ISDN incoming voice command will divert calls coming into the BRI port to the Modem module if it detects a voice band (ie Modem) call.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: