Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can I configure a FEC (Fast Ether Channel) between a switch and a router?

I have a Catalyst 3550-24-SMI and a 3620 router. I want to have good throughput etween the switch and the router so I can install more fastethernet ports in the 3620. My question is can I configure a FEC (Fast Ether Channel) between the switch and the router and assign only one IP address to the FEC port in the router?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Can I configure a FEC (Fast Ether Channel) between a switch

The following page should help

http://www.cisco.com/warp/public/473/158.html

3 REPLIES
Cisco Employee

Re: Can I configure a FEC (Fast Ether Channel) between a switch

The 3600 series routers do not support FEC. If you have a 7200/7500, you can do this

New Member

Re: Can I configure a FEC (Fast Ether Channel) between a switch

And if I had a 7204VXR router, how should I do the FEC with the 3550?

Cisco Employee

Re: Can I configure a FEC (Fast Ether Channel) between a switch

The following page should help

http://www.cisco.com/warp/public/473/158.html

103
Views
0
Helpful
3
Replies
CreatePlease login to create content