cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
301
Views
0
Helpful
3
Replies

Can I configure a FEC (Fast Ether Channel) between a switch and a router?

clsmns
Level 1
Level 1

I have a Catalyst 3550-24-SMI and a 3620 router. I want to have good throughput etween the switch and the router so I can install more fastethernet ports in the 3620. My question is can I configure a FEC (Fast Ether Channel) between the switch and the router and assign only one IP address to the FEC port in the router?

1 Accepted Solution

Accepted Solutions
3 Replies 3

Prashanth Krishnappa
Cisco Employee
Cisco Employee

The 3600 series routers do not support FEC. If you have a 7200/7500, you can do this

And if I had a 7204VXR router, how should I do the FEC with the 3550?

The following page should help

http://www.cisco.com/warp/public/473/158.html

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: