Can I Configure an Etherchannel from 2 Separate Modules?
I want to setup a Gigabit channel on two separate modules, for redundancy. The channel would go from a Catalyst 6509 to a Catalyst 4006 using the 8-port Gigabit module on the Catalyst 6509 and the two Gigabit ports on the Supervisor Engine on the Catalyst 4006. For example, set port channel 3/1, 4/1
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...