Can I Configure an Etherchannel from 2 Separate Modules?
I want to setup a Gigabit channel on two separate modules, for redundancy. The channel would go from a Catalyst 6509 to a Catalyst 4006 using the 8-port Gigabit module on the Catalyst 6509 and the two Gigabit ports on the Supervisor Engine on the Catalyst 4006. For example, set port channel 3/1, 4/1
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.