Can I configure more than 16 HSRP groups on an MSFC2
I have a 6509 with dual MSFC 2's that I want to configure HSRP on. When I do it, everthing seems to work fine. Documentation I have found says that if I configure more that 16 groups, then I can't match Vlans to groups, but I dont care about that. Is there anything else wrong with configuring more that 16 groups on msfc's?
Re: Can I configure more than 16 HSRP groups on an MSFC2
this limitation is with the sup2- which has the pfc2. If you have the sup1a with msfc2 then there is no such limitation. If you have the sup2, then this is the hardware limitaion. You can use the group number again like for vlan 1-16 - group 1-16 then for vlan 17-32 group 1-16 again etc. No problems using same number in the different vlans.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...