Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can I replace a 3550 with a 4948-10ge

Can I use a 4948-10ge switch as a direct replacement for a 3550 switch. I'm concerned about the 10 gig uplink port on the 4948. Can it connect to a 1 gig gbic port on a 6509? Is there anyway to make this work?

thanks

1 REPLY
Silver

Re: Can I replace a 3550 with a 4948-10ge

you can replace the switch , but enable the proper configuration between the 4948 and 6509 switches ie speed , trunk modes, MTU , timer settings etc.

128
Views
0
Helpful
1
Replies