Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can I stack two 2950T-24 throught Giga Ethernet port?

I want to know if I can stack two Catalyst 2950T-24 throught Giga Ethernet port (10/100/1000 Mbps)?

  • Other Network Infrastructure Subjects
3 REPLIES

Re: Can I stack two 2950T-24 throught Giga Ethernet port?

Yes you can.

Just make sure you change the port to be "switchport mode trunk " on both sides and use Xover cables to connect them.

Regards

Shaheen

New Member

Re: Can I stack two 2950T-24 throught Giga Ethernet port?

You have to use a Gigastack GBIC to stack the switches together. If only a gig connection is required, then all you need is a 4-pair crossover cable.

RH

New Member

Re: Can I stack two 2950T-24 throught Giga Ethernet port?

29590T-24 is fixed port switch, does not support stacking.

For stacking you require to have GBIC slots and install Giga Stack modules in the GBIC slots.Use stacking cable for stacking.

However if you want more throuput you can cascade the 2 switches using 2*10/100/1000T ports with cross over cables.

206
Views
0
Helpful
3
Replies