cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
155
Views
0
Helpful
1
Replies

Can I use isdn backup interface together with backup load ?

admin_2
Level 3
Level 3

Since using the command backup interface

the bri int is in standby mode, will the backup load still kick in an isdn channel if load on a serial line is above a threshold ?

is q&a 3695 my example or is this backup load only working after the serial line was down ?

1 Reply 1

Not applicable

NO you cannot. The backup interface command would have already

put the isdn interface into standby and can be used unless

the primary serial interface goes down and the backup isdn kick in.

The backup load and backup interface need to be used seperately.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco