Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Can I use LS1010 as Mux to send Timeslots from an E1 as VCs on an STM-1

We have PSTN C7 signalling arriving in a PoP in timeslots in TDM E1s (2 timeslots per E1). We need to get them to another location and have an STM-1 link. Can we use Circuit Emulation E1 cards and send just the signalling timeslots over VCs on the STM-1?

Also, at the other end, can we demux the signalling timeslots back to CE E1s (probably in a more concentrated form than originally - more than 2 timeslots per E1).

1 REPLY

Re: Can I use LS1010 as Mux to send Timeslots from an E1 as VCs

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you, or there is no public information available at this time. If you don't get a suitable response to your post, you may wish to review our resources at the online http://www.cisco.com/go/solutions. You may also contact our product information line at 1-800-553-NETS or a Cisco Systems Engineer at your local Cisco office or reseller. To locate your local Cisco representative, visit http://www.cisco.com/warp/public/687/Directory.shtml

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

128
Views
0
Helpful
1
Replies
CreatePlease to create content