Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

can not copy file from TFTP server to CAT6500

I can not copy file from tftp server to switch, but I can copy file from switch to tftp.

--------------------------------------------------------------------------------------------------------

SWITCH> (enable) copy config tftp

This command uploads non-default configurations only.

Use 'copy config tftp all' to upload both default and non-default configuration.

IP address or name of remote host [192.168.0.1]? 192.168.0.1

Name of file to copy to [SWITCH.cfg]?

Upload configuration to tftp:SWITCH.cfg, (y/n) [n]? y

..............

..................

..................

....................

..

-

Configuration has been copied successfully.

SWITCH> (enable) copy tftp config

IP address or name of remote host [192.168.0.1]?

Name of file to copy from [SWITCH.cfg]?

Configure using tftp:SWITCH.cfg (y/n) [n]? y

File not found.

TFTP connection fail(0).

TFTP end abnormally (3)

Read file error (TFTP read error)

Cannot get file to buffer

Cannot copy from tftp:SWITCH.cfg to config:

--------------------------------------------------------------------------------------------------------

SWITCH> (enable) sh mod

Mod Slot Ports Module-Type Model Sub Status

--- ---- ----- ------------------------- ------------------- --- --------

1 1 2 1000BaseX Supervisor WS-X6K-SUP2-2GE yes ok

15 1 1 Multilayer Switch Feature WS-F6K-MSFC2 no ok

2 2 24 100BaseFX MM Ethernet WS-X6324-100FX-MM no ok

3 3 48 10/100BaseTX Ethernet WS-X6348-RJ-45 yes ok

--------------------------------------------------------------------------------------------------------

SWITCH> (enable) sh ver

WS-C6506 Software, Version NmpSW: 6.3(1)

Copyright (c) 1995-2001 by Cisco Systems

NMP S/W compiled on Jul 30 2001, 17:30:35

System Bootstrap Version: 6.1(4)

Hardware Version: 3.0 Model: WS-C6506

Mod Port Model Versions

--- ---- ------------------- ----------- --------------------------------------

1 2 WS-X6K-SUP2-2GE Hw : 3.2

Fw : 6.1(4)

Fw1: 6.1(3)

Sw : 6.3(1)

Sw1: 6.3(1)

WS-F6K-PFC2 Hw : 3.0

.

.

.

15 1 WS-F6K-MSFC2 Hw : 1.3

Fw : 12.1(8a)E5

Sw : 12.1(8a)E5

DRAM FLASH NVRAM

Module Total Used Free Total Used Free Total Used Free

------ ------- ------- ------- ------- ------- ------- ----- ----- -----

1 130944K 61761K 69183K 32768K 7101K 25667K 512K 278K 234K

--------------------------------------------------------------------------------------------------------

2 REPLIES
Cisco Employee

Re: can not copy file from TFTP server to CAT6500

Which TFTP server do you use? Try tftpd32

http://tftpd32.jounin.net/

Regards

-Prashanth

tim
New Member

Re: can not copy file from TFTP server to CAT6500

Use TFTPSuite

http://www.walusoft.co.uk/

Works everytime

167
Views
0
Helpful
2
Replies
CreatePlease to create content