Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can not exec "show running" command

We have a problem with the main enterprise router.

The message console when I introduce "show running" is:

%SYS-2-MALLOCFAIL Memory allocation of 116 bytes failed from 0x802F1BEC, pool Processor, alignment 4

I checked the memory and I obtain:

Total 22430528

Free 1902836

I can execute others commands.

Also I have an access list for denying ICMP to prevent Welchia Virus Attack (thousands of confirmations)

Can help any body to identify the problem ?

Thanks very much in advance

1 REPLY
New Member

Re: Can not exec "show running" command

Probably the virus attack caused a memory fragmentation. I red an interesting conversation on the forum about this, few days ago. Maybe you can try to reboot the system, but you must eliminate the virus first.

81
Views
0
Helpful
1
Replies