Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can not see V.90 WIC 2 AM ond Cisco 3640?

I pluged two WIC 2 AM two ports module v.90 in Cisco 3640.After reboot I can not see the interfaces in my configuration.I have Cisco 3640 IOS IP PLUS IP SEC 3DES (c3640-ik9s-mz.122-17a.bin). I have 16 MB flash and 64 MB RAM.What is the problem?

Kind Regards

Enes

1 REPLY
New Member

Re: Can not see V.90 WIC 2 AM ond Cisco 3640?

I've seen this once before, I had to swap the cards around a bit and eventually it found the new modules.

Of course you need to adjust your config to reflect the new arrangement, time consuming, but it worked for me.

I had the same problem but it was with 2 x NM-2FE2W cards.

76
Views
0
Helpful
1
Replies