Hi! I can't seem to access a server inside a network (which is using NAT) from the outside, although I can ping it and I can telnet into that router. I have my server statically defined (ip nat inside source static 10.1.0.7 198.XXX.XXX.XXX). Any ideas or a routing issue I can check. Everything else is fine (inside users can access Internet, etc). This is the only server that we have to access from the outside, and is not a webserver, just a file server.
Make sure that the public address that you are using for your server is not incuded in the pool of addresses that you use for the other pc on the network that do not need static translation. Also check the access lists, make sure you are not denying the traffic to the server. One more thing, if you can ping the public address of the server from the outside, than the NAT is working fine, in that case you have some issue with the access lists
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.