Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

can't change console baud rate for router 2600

Break at boot rom, issue command "confreg 0x2102". After reset, the baud rate is still 115200. Show ver, it shows: "Configuration register is 0x2102 (will be 0x3922 at next reload)" confused

5 REPLIES
Silver

Re: can't change console baud rate for router 2600

Try the following:

r#config t

r(config)#config-register 0x2102

r(config)#end

r#copy run start

r#reload

New Member

Re: can't change console baud rate for router 2600

Thanks for reply, Ahmed.

This was tried as well, it didn't work at all.

Cisco Employee

Re: can't change console baud rate for router 2600

What is the exact problem you are talking about. Is it configuration register problem or console baud rate problem. Please give a clear explanation of the problem.

-amit singh

Cisco Employee

Re: can't change console baud rate for router 2600

Check under the lin Con 0, if the baud rate is 115200. Change it there are 9600. Try reloading the router and check what happens.Please paste the router config.

-amit singh

New Member

Re: can't change console baud rate for router 2600

I was trying to reset the baud rate of console to 9600, so I tried to set conf-reg, but the register always keeps 0x3922. Getting your hint, I checked the speed for console, it was 115200 in running config. After it was changed to 9600, and rebooting, the register is 0x2102 now.

Appreciate your help!

1103
Views
5
Helpful
5
Replies
CreatePlease login to create content