02-20-2003 09:27 AM - edited 03-02-2019 05:15 AM
hi, I try to get access to the console of 2620 with out success, Can I access the configution thru ethernet 0 on thru IP.
thank you
02-20-2003 09:24 PM
Make sure to use the correct cable and hyperterminal setting on a pc as 9600,8,N,1. If it still doesn't work, you may have a dead console port.
02-21-2003 06:43 AM
do a "sho run" and scroll down to "line con 0". Make sure that everything looks normal. Check especially for "speed" commands. Also, do you get anything on the console if you power-cycle the router? Does that console cable work on other routers?
02-22-2003 06:50 PM
I had this problem once, and I had to use the jumpers on the mother board to reset the routers console interface to 9600. Here is the link that explains how to do this. http://www.cisco.com/warp/public/701/59.html
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: