Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Can't establish ISIS L1 link over ATM PVC

Hello,

I' have C7507 and C7206VXR, both with PA-A3-OC3SMI. I've configured subinterfaces, vpi and vci, ip addresses. Ping works fine. EIGRP neighbors esablished fine.

But ISIS doesn't. I've entered "debug isis adj-packets" and found that both end system send IIH (ISIS hello), but one of them doesn't receive it.

Maybe it is a matter of "protocol clns ..." command ?

Thanks in advance

2 REPLIES
New Member

Re: Can't establish ISIS L1 link over ATM PVC

When you say you've configured subinterfaces I assume those are p2p and not p2m interfaces? IS-IS only works on p2p.

Have you mapped CLNS to the proper vpi/vci using "protocol clns ..."?

Although it's on Frame Relay and not ATM perhaps this page may help:

http://www.cisco.com/warp/customer/97/isis-frint.html

New Member

Re: Can't establish ISIS L1 link over ATM PVC

Thanks for replay. Actually I've solved problem by myself - I've found the solution on :

<http://www.cisco.com/en/US/tech/tk365/tk381/technologies_white_paper09186a00800a3e6f.shtml>. It states:

-------------------

By default, IS-IS hellos are padded to the full maximum transmission unit (MTU) size

-------------------

The solution was to reduce MTU on subinterface. It is still not very clear which component - cisco routers or Alcatel ATM switches are tricky with MTU (it was 4470 - now 4400).

89
Views
0
Helpful
2
Replies
CreatePlease to create content