Can't ping FR switch (DCE) from router (DTE)

[yalexh22]

I have ran most of the show and debug commands and seems like everything is up and running (active), but I can't seem to be able to ping or telnet between the router and the switch. The only thing I can think of is that I configured the routing protocol incorrectly. I've tried using OSPF, EIGRP, and RIP. Below is the result of the show frame-relay pvc and show frame-relay map command.

FRswitch#show frame-relay pvc

DLCI = 101, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial0

input pkts 22 output pkts 7 in bytes 1408

out bytes 448 dropped pkts 0 in FECN pkts 0

in BECN pkts 0 out FECN pkts 0 out BECN pkts 0

in DE pkts 0 out DE pkts 0

out bcast pkts 7 out bcast bytes 448

pvc create time 01:44:59, last time pvc status changed 01:42:12

FRswitch#show frame-relay map

Serial0 (up): ip 10.0.227.1 dlci 101(0x65,0x1850), static,

broadcast,

CISCO, status defined, active

Any help would be greatly appreciated.

Alex

[sirisak.c]

http://www.cisco.com/univercd/cc/td/doc/cisintwk/itg_v1/tr1918.htm

[yalexh22]

Thanks for the link. I've ran across the link before and tried to do what it said. I can ping the local interfaces but not any other interfaces on the other routers.

[sirisak.c]

Frame Relay is running on Layer 2 of OSI

Ping is running on Layer 3 of OSI

...

Try to use subinterface rather than physical interface.

[sirisak.c]

http://www.cisco.com/warp/public/116/fr_faq.html