can u give me some guidlines?

[bin-pan]

a central office and a remtoe office ,in central office there is a cisco 2600 with a bri interface(s/t) ,and in remtoe office there only is a PC with a TA pro(U),so I can conncet between the two through isdn network.The problem come out when I dial into cetral offcie from remote office using the PC.

" recovery on timer expriy"(Q931),the router tell me that.What dose this mean ?What can I do with it?

Also ,here is my configuration.

username test password 0 password

interface bri0/0

encap ppp

ppp authentication chap

dialer pool-memeber 1

interface dailer 1

ip addr 131.43.166.110 255.255.255.252

peer default ip addr 131.43.166.109

dialer remote-name test

dialer pool 1

dialer-group 1

encap ppp

ppp au chap

......

Is it right?

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.