Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can you send me a sample configuration for a 2948g-l3 switch using it as a switch connected to a 2500 router routing both IP and IPX using EIGRP?

I want to use this switch at a remote site. It will connect back to master site via 2500 router using a frame-t1. I need to route both ip and ipx traffic. Do I have to assign a separate ip address and ipx network number for each interface? I really want to use this as just a switch.

1 REPLY
Anonymous
N/A

Re: Can you send me a sample configuration for a 2948g-l3 switch

yes, you can use this as the switch.

Enable bridge,

From config t mode:

bridge irb

bridge 1 protocol ieee

bridge 1 route ip

Go to the interfaces like

int fast 3

bridge-group 1

So which ever interfaces you want to use as the part of the same lan, make it part of that bridge group by going to the interface mode and type " bridge-group 1"

89
Views
0
Helpful
1
Replies