I am trying to connect a remote intranet server which is located in HQ but the connection fails.When i ping the remote server from my branch office i can ping and also tracert can reach properly .But when i try to browse the server (HTTP) fails.Hq and branch office connected via ip/vpn.
even my ftp fails to connect to the remote server .
Re: cannot able to connect to remote intranet server
You are able to ping, so IP routing is working to some extent.
Seems like you are hitting a firewall that does not allow incoming tcp traffic. This is the default behaviour for a firewall. On a PIX, you can enble ICMP by using a conduit-statement. This is appearently configured.
You could also run into trouble because the firewall runs PAT and there are no static translations defined.
Try changing the access-lists that specifies your VPN-traffic to be excluded from NAT/PAT and enable incoming traffic from the VPN.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...