Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cannot access my 7204 router via telnet and console

In need urgent help, I cannot establish a connection into my 7204 router by telnet and through the console, there 's a message reading MALLOCFAIL- memory allocation 0f 128975 bytes failed freom 0x600c6680

1 REPLY

Re: Cannot access my 7204 router via telnet and console

Please review this document on Cisco.com

http://www.cisco.com/warp/public/63/ts_codred_worm.shtml

The focus of this board is Content Delivery Networking (http://www.cisco.com/go/cdn) however there are a number of professionals online who may be able to assist you. We are always considering additional forums for such topics and I will make a note of your post.

If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread. Thank you for posting.

239
Views
0
Helpful
1
Replies
CreatePlease to create content