Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

cannot communicate

hi everyone,

i tried to connect a 1720 series and a 2500 series router using a male v.35 and a female v.35 together. i had change the serial interface to full-duplex for both the router and can configure the colck rate to 56000. but i still cant get the router to communicate. can anyone please advice me. thanks a lot in advance.

1 REPLY
Silver

Re: cannot communicate

can you past in a config for each serial interface and a sh controllers for each serial interface

77
Views
0
Helpful
1
Replies