Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

cannot console in or telnet to Router

Router console connection will not open and connect. Cannot telnet to the Router as well. Any suggestions? This is on a frame relay hub and spoke router that is in production. Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: cannot console in or telnet to Router

Speed in the terminal emulation software could be the issue and flow control should be set to none. Also, it could be caused be memory problems. If memory gets highly utilized or fragemented telnet and console sessions won't open and the only fix is a reboot.

3 REPLIES
Silver

Re: cannot console in or telnet to Router

Try changing the speed in Hyperterminal (or whatever ap your using). Maybe someone changed the speed of the port.

New Member

Re: cannot console in or telnet to Router

Speed in the terminal emulation software could be the issue and flow control should be set to none. Also, it could be caused be memory problems. If memory gets highly utilized or fragemented telnet and console sessions won't open and the only fix is a reboot.

New Member

Re: cannot console in or telnet to Router

We got in thru the aux port had same settings as the console port. were able to clear the console and all telnet sessions. everything fine now. thanks for all your help.

110
Views
0
Helpful
3
Replies
CreatePlease to create content