Re: Cannot Establish Gigabit Link Between Catalyst Switches and
The flow control settings must match on both sides for the link to come up. It is highly recommended that you configure auto-negotiation to on for both devices. (Auto-negotiation is enabled by default on all Catalyst switches.) Otherwise, if you have a layer 1 problem, the link remains up and a unidirectional link will result.
The initial software releases that support Gigabit Ethernet on the GSR router do not support gigabit auto-negotiation.
The following command configures gigabit auto-negotiation on the Catalyst 6000/6500:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...