Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cannot get into enable mode???

I cannot get into enable mode I get the following error message

% Error in authentication.

1 REPLY
VIP Purple

Re: Cannot get into enable mode???

Hello,

which device do you have (e.g. Cisco 2811 router) ?

Have you been able to get into enable mode before ?

You might want to try a password recovery, check this link:

Password Recovery Procedures

http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_tech_note09186a00801746e6.shtml

HTH,

GP

173
Views
0
Helpful
1
Replies