I have configured NAT with my router, when I telnet to the router and try to ping to any other public IP, it fail. But when I ping a public IP on my workstations and its ok. But why can't I ping when I telnet to the router. Pls advice.
Does the interface of the router that faces the internet have a public IP address? I worked for an ISP once who put private IP's between the POP's and the customer sites. None of the customers could ping the internet from the router because the source would be the private IP on the serial interface. The work around was to use extended ping and specify the interface with a public IP as the source. If that is not the case, post your config (without real IPs) and someone will figure it out.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.