I have a LAN with a netware server. The server is plugged into port FE0/22 on the Cisco 3560 cat. From the switch I can ping and telnet to the server. As soon as I try from outside I cannot ping nor telnet to the server. However from outside I can ping and telnet to the switch which indicates the router has no ACL to block the icmp packets for the address range my devices use.
The switch has a basic setup. Login username and password. Vlan1 which the server belongs to. And a Vlan200 but there is currently no device(s) connected to that vlan.
What am I missing that I cannot access the server from outside the LAN?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...