Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cannot route 2 Ethernet LAN segments using Cisco 1605R

Why can't I ping computers connected on Ethernet 2 from computers on Ethernet 1.(by the way all computers gateway connected on Ethernet 1 is the ip address of Ethernet 1 port of the router). I dont have any access-list. I just want only to connect the two networks. Also my IOS is c1600-y-mz.120-17. (with 4MB of flash and 8 MB of memory). Here is my configuration:

!

!

interface Ethernet0

ip address 172.29.168.6 255.255.255.0

no ip directed-broadcast

interface Ethernet1

ip address 172.29.162.7 255.255.255.0

no ip directed-broadcast

Hope you can help me,

Renan

3 REPLIES

Re: Cannot route 2 Ethernet LAN segments using Cisco 1605R

Seems you have a problem with your network, but you do not know where.

Try the following step-by step method:

From the PC on e0, ping to router's e0, if succesfull, ping to e1.

If these are working both, routing for e0 and it's attached PC is working OK.

Then, still from the same node, ping to a PC on e1. If the above works, and this doesn't, the PC on e1 is the cause. Repeat the sequence above for all nodes. When you have a non-working situation you will be able to determine where your problem is coming from.

Goodluck.

New Member

Re: Cannot route 2 Ethernet LAN segments using Cisco 1605R

Hi

I don't know if your probleme has been resolved or not

so if not send me the configuration file and for seen if all command lines are right!!

@+

New Member

Re: Cannot route 2 Ethernet LAN segments using Cisco 1605R

To All,

Thanks to all, my problem are already solved it is regards to my crosscable. It is been connected to wrong port.

Thanks,

Renan

95
Views
0
Helpful
3
Replies