hi all,
recently, i was successful in configuring link bundling to aggregate two E1 links to form one 4Mbps WAN pipe on 1760 access router. now i need to configure another router in the same way and cascade them together to get an 8Mbps link. i tried using Multichassis MLPPP but the router would not accept any SGBP commands. here is what i have so far:
username BOB password 0 BILL
tdm clock E1 0/0 both export line
tdm clock E1 1/0 both import E1 0/0 internal
ip subnet-zero
!
!controller E1 0/0
framing NO-CRC4
channel-group 0 timeslots 1-31
!
controller E1 1/0
framing NO-CRC4
channel-group 0 timeslots 1-31
!
!
interface Multilink1
ip address x.x.x.x y.y.y.y
ppp multilink
multilink-group 1
!
!
interface Serial0/0:0
no ip address
encapsulation ppp
ppp authentication chap
ppp multilink
multilink-group 1
!
interface Serial1/0:0
no ip address
encapsulation ppp
ppp authentication chap
ppp multilink
multilink-group 1