Yes these switches are layer 3 switches and you can create seperate vlans creating logical interfaces for vlans which are known as SVI interfaces and all the vlans can talk to each other.
Make sure you enable "ip routing"
Make sure whatever layer 3 interfaces you create for vlans you have aleast one trunk to make all those layer 3 vlans active or you have atleast one machine each vlan connected on physical ports to make the layer 3 interface up and up.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...