Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

cat 4006 error in sh epc status

my cat 4006 got hanged . when taking the sh tech support i found the following. and after restarting it showed ok. given below is sh epc status before and after restart.

Before restart *****

------------------ show epc status ------------------

Status of GigabitEthernet1: OK

Status of GigabitEthernet2: OK

Status of GigabitEthernet3: OK

Status of GigabitEthernet4: not OK - aborting this command

After Restart *****

B_4006_L3#sh epc status

Status of GigabitEthernet1: OK

Status of GigabitEthernet2: OK

Status of GigabitEthernet3: OK

Status of GigabitEthernet4: OK

can any one explain..

thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: cat 4006 error in sh epc status

It normally indicates bad hardware but looks like it came back in your case. Make sure the card is seated firmly and if it happens again, open a TAC case

2 REPLIES
Cisco Employee

Re: cat 4006 error in sh epc status

It normally indicates bad hardware but looks like it came back in your case. Make sure the card is seated firmly and if it happens again, open a TAC case

New Member

Re: cat 4006 error in sh epc status

suspecting the problem with the RSM module.

RMA raised.

replaced the RSM card. network performing normal.

thanks a lot.

rajendra

105
Views
0
Helpful
2
Replies
CreatePlease to create content