10-30-2002 12:51 PM - edited 03-02-2019 02:31 AM
Does anyone know if the RSM has to be installed in slot 3 or higher (like the Cat 5000 series) or can it be installed in slot 2? I get an error trying to connect to "session 2" . If it has to be in slot 3 that would make sense....
Thanks in advance!
11-05-2002 01:28 PM
As the per this URL, the switching modules can go on any slot 2 to 6. I would only suspect any seating problem and version compatibility issues here.
Just check if the module is recognisied by issuing the "show module" command. If it is not try a suitable catOS on the supervisor that would support this RSM.
Also check if the card is seated properly
11-05-2002 05:36 PM
WS-X4232-L3 can go into any slot from 2 through 6. Make sure the Supervisor 2 is running 5.5(1) and above. If you have the IOS based Supervisor 3 engine, the WS-X4232-L3 will not be recognized.
Are you able to telnet to the IP address of the RSM? Do you see it as CDP neighbor? Also take a look at the following bug
http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCds08233
Let us know if this helps.
11-05-2002 06:18 PM
I'll try the router reload as the bug states. In case I am missing something obvious I have pasted in the 'sh ver' and 'sh cdp nei' outputs as well as the error. Thanks for assisting.
C4006> (enable) sh ver
WS-C4006 Software, Version NmpSW: 6.1(1)
Copyright (c) 1995-2000 by Cisco Systems, Inc.
NMP S/W compiled on Sep 30 2000, 12:25:52
GSP S/W compiled on Sep 28 2000, 18:28:28
System Bootstrap Version: 5.4(1)
Hardware Version: 3.2 Model: WS-C4006 Serial #: JAB0526080Z
Mod Port Model Serial # Versions
--- ---- ---------- -------------------- ---------------------------------
1 2 WS-X4013 JAB0526080Z Hw : 3.2
Gsp: 6.1(1.0)
Nmp: 6.1(1)
2 34 WS-X4232-L3 JAB052905VZ Hw : 1.7
4 34 WS-X4232-GB-RJ JAE053000H5 Hw : 2.3
6 48 WS-X4148-RJ JAB0529088J Hw : 3.0
DRAM FLASH NVRAM
Module Total Used Free Total Used Free Total Used Free
------ ------- ------- ------- ------- ------- ------- ----- ----- -----
1 65536K 30673K 34863K 16384K 4753K 11631K 480K 208K 272K
Uptime is 118 days, 11 hours, 16 minutes
C4006> (enable) sh cdp nei
* - indicates vlan mismatch.
# - indicates duplex mismatch.
Port Device-ID Port-ID Platform
-------- ------------------------------- ------------------------- ------------
1/1 CAT2948 GigabitEthernet49 cisco Cat2948
G
2/2 RSM GigabitEthernet4 cisco Cat4232
L3
C4006> (enable)
C4006> (enable) session 2
Trying IntlgLineCard-2...
session: Unable to tunnel to IntlgLineCard-2
C4006> (enable)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide