Cat 4k HELP NEEDED! %SYS-4-P2_WARN: 1/Astro(5/1) - timeout is persisting
This sys message keeps appearing on my catalyst 4000. There is no device connected to port 5/1, yet the message continues to appear. All resources are well within normal operating ranges. Furthermore, no one port seems to be generating more traffic than any other. Has anyone seen this issue and resolved this issue before. I have already swapped out the chassis.
We have both voice and data flowing through the box via 48 port power blades.
Re: Cat 4k HELP NEEDED! %SYS-4-P2_WARN: 1/Astro(5/1) - timeout i
This means the supervisor has stopped talking to the asic for that particular port . You can try reseating the cards and the supervisor and see if the messsages go away . We have seen more than few cases of this and in almost every case we ended up replacing the Supervisor card .
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...