Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cat 500 disabled port state

I have a couple of Cat 500 express routers in a two building network connected with wireless access points. I had a wireless drop to due to a user unplugging the wireless AP and my switch put my port into disale state "due to traffic only passing in one direction" Is this something that i can avoid having to deal with in the future or is it software feature that you have to deal with on the lower end switches?

2 REPLIES
Silver

Re: Cat 500 disabled port state

Hi Nathan

Configure that port as "Access Point" or "Other" in order to disable port security policy in that port.

Hope this helps

New Member

Re: Cat 500 disabled port state

ok thanks i will give that a shot and see if that works. I remember though when I first set this site up I had set each of the ports on those two switches to Access Point...i wasnt able to pass traffic and hit another IP?? I had to set the port to Router in order for it work properly....

SW1---AP1======Bridge=====AP2---SW2

thats my layout....

thanks for the help...

145
Views
0
Helpful
2
Replies
CreatePlease to create content