Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

cat 5005: Can not load image via xmodem???

After loading an image to the cat 5005 via "xmodem" an error message is generating indicating:

*** TLB (Load/Fetch) Exception ***

Access address = 0x2eec

PC = 0x80010604, Cause = 0x8, Status Reg = 0x3041d003

monitor: command "xmodem" aborted due to exception

Any clues or suggestions???

1 REPLY
Cisco Employee

Re: cat 5005: Can not load image via xmodem???

Try downloading fresh CAT OS and try different baud rate(lower than what you used before). If you have the time, try it at 9600. Also what Sup and what version do you have

Regards,

-Prashanth

143
Views
0
Helpful
1
Replies