Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cat 6000 and 720 sup engine

How do we get the MSFC3 to be seen by the switch?

Doing a show mod shows the sup eng but not the MSFC. In

the older sup 1 you could get to the MSFC with the

sessions comand. Doing session command with sup 720 we

get "module not installed". Thoughts anyone ?

  • Other Network Infrastructure Subjects
1 REPLY
New Member

Re: Cat 6000 and 720 sup engine

Your MSFC3 may be on ROMMON. Connect a terminal on the console port and do the following:

"switch console"

that should take you to the ROMMON prompt. From there issue the "boot" command and that should get you going.

95
Views
0
Helpful
1
Replies