I have a 6506 with two MSFC2 (Module 15 & 16). One of the modules, in the 6506, is a Flexwan (ws-6182-2PA) with a PA-A3-OC3 installed. The ATM interface is visible and working on the Module 15 MSFC2 but is not visible on the Module 16 MSFC2. I would like to have the ATM interface visible on both MSFC2.
"In a redundant MSFC configuration, the FlexWAN module interfaces appear only on the designated MSFC. To configure the FlexWAN module interfaces on the redundant MSFC, you must force a switchover. The interfaces can be configured and the configuration can be saved. The saved configuration is used on the redundant MSFC if a switchover occurs. "
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...