Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cat 6509

Hello Guys,

i am trying to configure the cat6509 and get this Prob:

the layer 3 Modul is giving me this prompt: router (boot)#

after rebooting the switxh i am not ´more able to connect to layer 3

SW01-6509GL7-11> (enable) session 15

Trying Router-15...

session: Unable to tunnel to Router-15 (57)

please helb me

Alain

3 REPLIES
Silver

Re: Cat 6509

Hello Alain

Try to use the command "switch console" or "swith console 15" , you have to be directly connected to the sup console to do this. If you reset the mod 15 just before switching console you can see the startup.

Regards

Mike

New Member

Re: Cat 6509

Hello Mike,

thanks for replaying me. I try the command "switch console 15" and get this message

%SYS-6-READ_BOOTFILE_FAIL: tftp://255.255.255.255/flash:c6msfc2-is-mz.121-2.E No usable interfaces.

Sleeping for 300 secs before next netboot attempt

but no connection

Thanks for any help

Alain

Cisco Employee

Re: Cat 6509

Issue a "reset 15", then "switch console" in and send a break sequence to break into rommon. You might have to recover MSFC using procedures in the following tech tip

http://www.cisco.com/warp/public/473/124.html

98
Views
4
Helpful
3
Replies
CreatePlease to create content