Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

cat2900,PCs cant ping to each other

fellow networkers

i have a 2900 xl switch..where i cant ping pcs if i put them on 2900 but if i shift them to 1900 .,they all ping..i accept could be a duplex/speed mismatch of ports..i have compaqs, even if i erase all the config..just blank switch..still teh problem persists

enlighten pls

shukky

2 REPLIES
Community Member

Re: cat2900,PCs cant ping to each other

If you are sure about the blank switch and having all ports enables auto/auto in the right vlan and are not able to ping even the management interface configured in the same vlan / ip net, i would say it's broken. Some of these switches seem to have faulty components witch could cause these simtoms.

pls read

http://www.cisco.com/warp/public/473/164.html

http://www.cisco.com/warp/public/770/fn26174.shtml

Duplex fault would just show bad troughput but usually not all frames are lost under low traffic conditions, losses start going up if traffic increases.

Community Member

Re: cat2900,PCs cant ping to each other

thank you , ill find out the solution now

88
Views
0
Helpful
2
Replies
CreatePlease to create content