Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Cat2940 IOS add to RME library

I've just added a new Cat2940-8TT-S to my network.

I downloaded the proper device package to Device Manager and CiscoView works fine.

I've got it in the RME inventory. I'm able to get the config from the device to RME.

BUT trying to add the IOS to RME library from CCO I don't see C2940 in the available device list.

What am I doing wrong?

I'm able to get the IOS to the library from the local disk, but why not directly form CCO?

I'm able to download IOSes for other platforms, but Cat2940 is just not offered when connecting to CCO from my RME.

I'm running RME 3.5 with IDU 5.0.

Regards,

Milan

2 REPLIES
Silver

Re: Cat2940 IOS add to RME library

It could have been obsoluted from CCO. Where are you getting it from CCO?From Software Center?? Some times, due to some changes in the Cisco Site, the images are pulled out from CCO. You need to keep checking after some days, if you are lucky, the image might be pushed back to CCO.

New Member

Re: Cat2940 IOS add to RME library

Its available on CCO software center now. :)

Check this:

http://www.cisco.com/cgi-bin/tablebuild.pl/cat2940

116
Views
6
Helpful
2
Replies
CreatePlease login to create content