Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CAT2948-L3 Configuration

I want to create 2 vlans in my 2848-l3 switch.Port 1-24 will be in vlan 1 and ports 25-48 will be in vlan 2.Vlan 1 will be connected to secured interface of PIX and Vlan 2 will be connected unsecure interface of PIX firewall.If clients in vlan1 want to connect to any of the client in vlan2 then all of them must be going thru PIX only.Can i have sample configuration for the above said configuration.I will be grateful to you.Mail me back only at sungoel@yahoo.com.

2 REPLIES
v.j
New Member

Re: CAT2948-L3 Configuration

one way to do this is throuvh BVI.

ajd
New Member

Re: CAT2948-L3 Configuration

well I can help you with the pix config. the switch is easy, just goto www.cisco.com and look up 2800 command reference.

the pix:

inside (whats your ip range)?

outside (what your ip range)?

dmz (what do you want your range to be)?

just so you know the pix is not a router so if you think there is alot of traffic going back and forth look into a 2600 or "router on a stick".

-ne1secure?

113
Views
0
Helpful
2
Replies