Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cat2950 LACP interop issues

Hi

i am struggling to get LACP on the 2950s to interoperate properly with 3com and HP switches. I configure the 2-port Gig LACP trunk as active, disable autoneg, but when i test link failover the trunk does not come up for more than 25 seconds. The same configuration parameters across HP and 3com work fine (sub 5sec failover)

can someone advise if there is special tweaking i need to configure ?

thanx

PG

143
Views
0
Helpful
0
Replies
CreatePlease to create content