Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

cat3524-pwl port status in cms

did anyone ever seen this funny problem:

any cat3524 on a stack is showing the port statuses ok (on ,off, admin down etc) but the 3524-pwl (with "inline power" for ip-phones) do not show any status on any port!

4 REPLIES
Cisco Employee

Re: cat3524-pwl port status in cms

What software version are you running? Paste the output of "sh ver" and "dir flash:". Take a look at the following bug which was closed unreproducible

http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCdx90717

Try to delete and reinstall html files

New Member

Re: cat3524-pwl port status in cms

i am using the newest version 12.0(wc5) with new html files

note: the problem is not with the ios version

couse it is ok on non-PWR capable switches!!

there is a case opened on that issue

i think it is an unknown bug...

Cisco Employee

Re: cat3524-pwl port status in cms

CSCdx90717 was openened for inline power switch and was marked unreproducible. Since you have opened a TAC case, I suggest that you provide all the relevant info to the TAC engineer

New Member

Re: cat3524-pwl port status in cms

thanks

the problem is fully reproducible 'couse i see it!

i think TAC will have to get a hold of the bug this time

i provided all the relevant info to the TAC engineer

107
Views
0
Helpful
4
Replies