cat3524-pwl port status in cms

korenlev · ‎08-25-2002

did anyone ever seen this funny problem:

any cat3524 on a stack is showing the port statuses ok (on ,off, admin down etc) but the 3524-pwl (with "inline power" for ip-phones) do not show any status on any port!

Prashanth Krishnappa · ‎08-25-2002

What software version are you running? Paste the output of "sh ver" and "dir flash:". Take a look at the following bug which was closed unreproducible

http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCdx90717

Try to delete and reinstall html files

korenlev · ‎08-27-2002

i am using the newest version 12.0(wc5) with new html files

note: the problem is not with the ios version

couse it is ok on non-PWR capable switches!!

there is a case opened on that issue

i think it is an unknown bug...

Prashanth Krishnappa · ‎08-27-2002

CSCdx90717 was openened for inline power switch and was marked unreproducible. Since you have opened a TAC case, I suggest that you provide all the relevant info to the TAC engineer

korenlev · ‎08-28-2002

thanks

the problem is fully reproducible 'couse i see it!

i think TAC will have to get a hold of the bug this time

i provided all the relevant info to the TAC engineer