I just installed a stack of 6 3750-48TS and another stack with 2 3750-48ts and 1 3750-24TS. Running 12.2-18SE.
Everything is working fine except one minor isssue. When i make any kind of change in config mode, once i exit out of config mode, it slows down for about 5-7 seconds (trying to type "sh run" takes a little while). I see this issue when i am directly connected to the switch.
Any thoughts on why this is occuring and whether this is normal?
Apparently this is a bug on the 3750. Here is what what i was advised
ossible issue : CSCea30724 (J)
When the user exits config mode, he may observe high CPU utilization for a short period of time. This is because the running configuration of the entire stack needs to be regenerated and propagated to all stack members. There is no undesired side-effect.
None required since this is the expected behavior.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.